PeakLab v1 Documentation Contents            AIST Software Home            AIST Software Support

GenNLC[Y]

GenNLC[Y] - [Y] ZDD

This is the one of the most important of the GenNLC models. The GenNLC[Y] model is a generalization of the GenNLC[Z] model where a₁ is the median of the asymmetric generalized normal ZDD.

By using the relationships of equivalence between the GenHVL and GenNLC models, we make the following simple substitution into the GenHVL[Y] model equation to derive the GenNLC[Y] model:

To convert the GenHVL[Y] to the GenNLC[Y], the a₂ is transformed to a Giddings kinetic time constant, the a₅ is transformed to a Gidding's indexed asymmetry.

a₀ = Area

a₁ = Center (as mean of generalized normal ZDD)

a₂ = Kinetic Width (Giddings time constant of ZDD)

a₃ = NLC/HVL Chromatographic distortion ( -1 > a₃ > 1 )

a₄ = Power n in exp(-zn) decay ( .25 > a₄ > 4 ), adjusts kurtosis (fourth moment)

a₅ = NLC indexed asymmetry ( -10 > a₅ > 10 ) a₅=0.5 NLC (Giddings), adjusts skew (third moment)

Built in model: GenNLC[Y]

User-defined peaks and view functions: GenNLC[Y](x,a₀,a₁,a₂,a₃,a₄,a₅)

In this plot, various a₄ values which adjust the kurtosis or fourth moment are shown for a series of fronted and tailed GenNLC[Y] shapes which vary only in this a₄ fat tail adjustment. The a₅ asymmetry is set at 1.5, a typical value for analytic peaks, an asymmetry greater than the theoretical NLC (a₅=0.5). An a₄>2 is a decay that is more compact than a Gaussian, and is seen in gradient HPLC. When used to fit non-gradient analytic peaks, the value is typically very slightly less than 2.0.

GenNLC[Y] Considerations

When a₄=2, the [Y] ZDD becomes a [Z] Generalized Normal and the model reduces to the GenNLC[Z].

When a₄=2 and a₅=0, the ZDD becomes a Gaussian and the model reduces to the HVL.

When a₄=2 and a₅=0.5, the ZDD becomes a Giddings and the model reduces to the NLC.

The GenNLC[Y] model adjusts both the third and fourth moments and is the model of choice for gradient HPLC peaks where a compression occurs from the gradient, and the decay of the peak will be more compact than a Gaussian (a power of 2.0 in the a₄ parameter).

In gradient peaks, the instrumental distortions may be masked entirely by the gradient. If the IRF is not removed or included in a gradient fit (neither may be possible), the a₅ parameter will reflect whatever measure of this IRF this skew adjustment is able to capture. Please note that the a₅ adjustment occurs to the skew of the ZDD to which the chromatographic distortion operator is subsequently applied, a very different matter than an IRF convolution integral applied to the end result of the intrinsic chromatographic distortion. The net effect of ignoring the IRF in a gradient fit is to have the a₄ understate the compression that is actually occurring in the gradient since it will be diminished to the extent it also accounts the tailing of the IRF.

We have found this a₄ fourth moment adjustment in the GenNLC[Y] model to often be overspecified (statistically insignificant) for non-gradient analytic peaks. The power is typically between 1.96-1.98, and as such the benefit of adding the kurtosis to the modeling will be small. You should use the GenNLC[Y] model cautiously for fitting analytic peaks. Use the F-statistic of the fit of the GenNLC[Y] model against the F-statistic for the GenNLC or GenNLC[Z] models to ensure there is an actual improvement in the modeling. The GenNLC[Y] F-statistic will increase in contrast with the GenNLC or GenNLC[Z] model when this adjustment to the fourth moment is statistically beneficial. A high S/N will definitely be needed to even see this benefit.

For fitting overload shapes, the GenNLC[Y] can be used, but the kinetics are not likely meaningful, and you will probably want to use the GenHVL[Yp] or GenHVL[YpE] specialization of the GenHVL[Y] model. These are designed specifically for fitting high overload shapes.

The GenNLC[Y]'s a₅ asymmetry parameter is indexed to the NLC and thus the absolute peak asymmetry is not independent of the peak's a₁ location. Use the GenHVL[Y] if you wish to fit an absolute statistical asymmetry.

This a₅ skew adjustment in the ZDD manages the deviations from the Giddings ideality assumed in the theoretical infinite dilution NLC. This is an asymmetry parameter indexed to the NLC at a₅=0.5. For most IC and non-gradient HPLC peaks, you should expect an a₅ between 1.1 and 2.0 (the deviation from non-ideality is right skewed or further tailed from the Giddings).

In most instances, both a₄ and a₅ can be assumed constant (shared) across all peaks in the chromatogram. It is strongly recommended that a₄ and a₅ be shared across all peaks and only independently fitted with each peak if the parameter significance allows and you find such necessary. In our experience, across a wide range of concentrations, and across peaks ranging from highly fronted to highly tailed, the fitted a₄ and a₅ were very close to constant if the S/N was strong.

The addition of a shared a₄ and shared a₅ parameter to an overall fit can result in orders of magnitude improvement in the goodness of fit.

The a₄ and a₅ are indicators of deviation from this ideality. Changes in the a₄ and/or a₅, in fitting a given standard, may well be indicative of column health. The greater the a₅ value varies from 0.5, the greater the deviation from this Giddings ZDD assumption of the NLC. The more a₄ drops in value from 2.0, the more the tailing is increasing, possibly from a slow 'drizzling' off the column.

Note that the a₅ will be most effectively estimated and fitted when the peaks are skewed with some measure of fronting or tailing. Higher concentrations are very good for this model, assuming that one does not enter into a condition of overload that impacts the quality of the fit.

This model will be least effective in highly dilute samples with a poor S/N ratio since such peaks will generally have much less intrinsic skew. Accurately fitting the tailing is even more demanding of data quality.

The GenNLC[Y]<irf> composite fits are available, the model with a convolution integral describing the instrumental distortions, in order to isolate the intrinsic chromatographic distortion from the IRF instrumental distortion, but this should be done with caution. The data must be of a sufficient S/N and quality to realize two independent deconvolutions within the fitting. For very dilute and noisy samples, you will probably have to remove the IRF prior using independent determinations of the IRF parameters.

The GenNLC[Y]<ge> model uses the <ge>IRF, consistently the best of the convolution models as it fits both kinetic and probabilistic instrument distortions. Bear in mind, however, that this fit must extract the kinetic instrumental distortion, the probabilistic instrumental distortion, the a₅ intrinsic skew to the chromatographic distortion, the a₄ compression or dilation of the tailing, and the primary a₃ chromatographic distortion (very possibly for for each peak). It is recommended the IRF parameters be determined by fits of a clean standard, and the instrumental distortions removed by deconvolving the known IRF prior to fitting more complex peak data.

Since peaks often slow in kinetic rates with retention time, the a₂ will probably be varied (independently fitted) for each peak.

Since peaks often evidence increased tailing with retention time, the a₃ will probably be varied (independently fitted) for each peak.

If you are dealing with a small range of time, however, or of you are dealing with overlapping or hidden peaks in a narrow segment, a₂ and/or a₃ can be held constant across the peaks in this band.

The GenNLC[Y] model is part of the unique content in the product covered by its copyright.